Sols 1061-1063: Sample dropoff to CheMin
31 July 2015This morning, the MSL operations team was very happy to see that drilling into Buckskin was successful! The weekend plan therefore has more arm activities, including transferring the sample to the scoop for inspection. But first, the ChemCam RMI will take pictures of… Read More
Sol 1060: GO for drilling!
30 July 2015It’s another exciting day on Mars! Curiosity is investigating some high-silica targets at an outcrop named “Lion.” The team selected the “Buckskin” target to drill, and we successfully completed a mini drilling test yesterday (shown in the above MAHLI… Read More
Sol 1059: Drill Testing and Analyzing "Ch-paa-qn"
29 July 2015Today the main event is a “mini-start hole”, which is the name for a new type of initial drilling test that we are trying out on the target “Buckskin”. This test will drill a small hole in the rock to help determine whether it is safe to go ahead with the full hole. In… Read More
Sol 1057-1058: Getting Ready to Drill Buckskin
27 July 2015The “bump” over the weekend was successful, so we are right where we want to be to attempt drilling at “Buckskin” in the “Lion” area. I was on duty as ChemCam sPUL (science payload uplink lead) today, and it was a fun day to be on duty. Sometimes it can be… Read More
Sol 1055-1056: Closing in on High-Silica Targets
24 July 2015The main priority in today’s plan is to nudge the rover a bit closer to the target “Buckskin”, which is in the area where we have discovered rocks high in silica and hydrogen. But before we do that, ChemCam and Mastcam will observe the targets “Marent”,… Read More
Sols 1051-1054: Approaching "Lion"
22 July 2015After driving just over 20 meters, the rover stopped 4.4 meters short of the Sol 1049 drive goal because the vehicle pitch exceeded the 15-degree limit set by the rover drivers. So another 6.4-meter drive toward the bright outcrop of interest, dubbed "Lion," was planned for Sol… Read More
Sols 1048-1050: Test drill and drive
17 July 2015The Sol 1046 wheel imaging completed nominally, and the rover is a little over 1 meter from its previous location. So the outcrop to the right of the vehicle is still close enough for ChemCam LIBS measurements, and I helped select new targets again today. The Sol 1048 plan… Read More
Sols 1046-1047: Wheel imaging
15 July 2015The 8.5-meter Sol 1044 drive completed as planned, leaving the rover in a relatively flat and smooth area that is suitable for imaging of the wheels. Wheel imaging is done periodically to assess wear, and it's time to acquire new data, so the Sol 1046 includes 5 sets of MAHLI,… Read More
Sol 1044-1045: Finishing the Drive
13 July 2015The drive over the weekend stopped a bit early (~17 meters instead of the intended ~25 meters) because the software that the rover uses to monitor its drive progress was being extra cautious. The rover is fine, and in the sol 1044 plan we will keep driving. Before the drive, ChemCam has… Read More
Sols 1041-1043: Busy weekend planned
10 July 2015The rover bumped back 33 cm on Sol 1039, placing all 6 wheels on firm ground and allowing contact science on the bright rocks near the top of the slope in front of the vehicle. So the weekend plan is a full one, including both contact science and a drive back toward the southwest. … Read More